How To Test Ge Dishwasher Control Board
How To Test Ge Dishwasher Control Board. The control board can be tested by unplugging the machine and removing the motherboard. Look for any signs of corrosion and clean with a soft pencil eraser.
Shut off the house circuit breaker for the dishwasher and test that membrane keypad as shown in that image. You can order parts from this page: The start button should start flashing.
How Does This 120 Vdc Ice Auger Motor Work.
How to clean bosch dishwasher. A bad control board can cause a myriad of problems, from buttons not working to the dishwasher not even starting. To open the dishwasher control board, press and hold the no heat dry button for 4 purposeful seconds and the lock on light should wind down.
It’s A Fairly Easy Fix.
You can order parts from this page: 340 received 0 votes on 0 posts how to test dishwasher control board. From a kenmore, is there a way to test with a dmm to verify the board is bad?
Do Not Close The Dishwasher Door.
To start a service test while in the ge profile washer service mode press the start button while the desired test number is displayed on the washers control. Dead dishwasher, won't enter service mode. Finally, hold the start and select cycle button down for five seconds.
Make Sure All Other Connections Are Made.
To determine if the control or keypad is faulty, do the following test: If not, perform the water level control test on ge front loader service mode. Unplug dishwasher or disconnect power.
Ui Personality Not Set, Communications Lost Between Ui (User Interface) And Mc (Machine Control Board).
That could refresh the connection, or you may need to replace the board. Open console and disconnect the keypad ribbon connection from the control (at p1). Check your main power connection where it comes in from your house electrical, it's in the metal junction box below your dishwasher, take the front bottom access panel off then you should see the junction box.
Post a Comment for "How To Test Ge Dishwasher Control Board"