Skip to content Skip to sidebar Skip to footer
Home / board / control / refrigerator / replace / samsung

How To Replace Control Board On Samsung Refrigerator

Post a Comment

How To Replace Control Board On Samsung Refrigerator. There should be two small clips on both the left and right sides of the display board. First, start by removing these four philips screws.

Refrigerator Dispenser Control Board Assembly (part
Refrigerator Dispenser Control Board Assembly (part from www.youtube.com

Refrigerator circuit board appliance parts, refrigerator main control board. The picture on the website matches the orientation of my original board. Refrigerator main electronic control board.

Remove The Cover On The Electronic Control Board.


Remove the electronic control board. If you do, remove the screw and then with a thin screwdriver or putty knife, release the clips that hold the dispenser in place. There should be two small clips on both the left and right sides of the display board.

Locate The Control Board Cover—Depending On The Model, It Could Be On The Back Of The Refrigerator, Or Inside The Refrigerator On A Side Wall Or The Ceiling.


With access to the back of the refrigerator, the control board’s located behind this panel. The replacement plug is orientated 180 degrees. For this repair, unplug or disconnect power to the refrigerator.

If Your Display Panel On Your Samsung Refrigerator Is Unlit Or Displaying Erratic Readings, It Might Be Necessary To Remove It For Diagnosis Or Replacement.


Step by step instructions on how to replace a main power control board for samsung rs261mdbp/xaa fridge too warm #ap4909012. You may have to pull the display away a bit. (drill squealing) with the screws removed, you can now pull off.

Carefully Pull The Refrigerator Forward And Unplug The Refrigerator.


If there is no continuity in defrost sensor or the fuse has been blown away, you must replace it. The temperature control board monitors the temperature sensors and starts the compressor and. Samsung refrigerator control board parts.

Restore Electrical Power And Connect Water.


Using a phillips screwdriver, remove the screws from the control board cover. It could be the main control board, the water inlet valve, the dispenser control board, the fan blade, or other replacement parts. The only time you can be sure that the board is the problem is when you have checked other parts of the refrigerator and everything is fine.

Post a Comment for "How To Replace Control Board On Samsung Refrigerator"