How To Change Hot Tub Control Panel
How To Change Hot Tub Control Panel. How do i replace my hot tub control panel? Most topsides are attached using silicone sealant or double stick tape.
Replacing a different topside control panel before you order a new spa pack or a different topside panel , check under the panel area for room to run the cord that connects to the new control box. Disconnect and remove the topside controller. Most topsides are attached using silicone sealant or double stick tape.
Yes, It Is Possible To Replace Hot Tub Control Panels.
Replacing a balboa control panel on a spa or hot. Before you begin to replace or install the control panel, you should turn off both the electricity and the water supply to your tub. In order to fully reset the control panel, users should manually turn it off or unplug it and wait 10 to 20 seconds.
Switch Of The Tub Before You Do Anything Electrical, It's Just Good Practice, Then Disconnect The Control Panel Cable From Control Box Or Circuit Board Inside The Hot Tub (Note You Will Almost Certainly Have To Remove A Side Panel From Your Hot Tub To Access The Hot Tub Control Box) , Do Not Remove The Cable At This Point As You May Need To Use.
Put your silicone sealant on the back of the hot tub control panel and push it into position. Now turn the power back on and see if the hot tub starts to filter or heat up. Disconnect and remove the topside controller.
If The Error Signal Continues On The Control Panel Then You Will Need To Consult Your Hot Tub Manual To See What The Problem Is.
Is it possible to replace hot tub control panels? Your unit may not have sufficient voltage to support the topside panel you have purchased. Most topsides are attached using silicone sealant or double stick tape.
Steps To Changing Your Hot Tub Settings.
If only part of the control panel is not working, check for any blinking lights or error messages. Enter “priming mode” on your control panel and test the buttons. Usually, it is just a case of disconnecting the control panel from your control box and removing your old unit from your hot tub.
Make Sure You Remove All Of The Silicon Sealant From The Tub.
If you experience any of the issues or signs above, the first thing to do is to reset the control panel of your hot tub. The most common method is to switch the hot tub off for about 20 seconds and then turn it on again. Using a spatula or the edge of your crow bar, clean off the old sealant.
Post a Comment for "How To Change Hot Tub Control Panel"