How To Test Control Board On Whirlpool Duet Dryer
How To Test Control Board On Whirlpool Duet Dryer. Be sure the dryer is unplugged. That’s the only thing that would make it act like that unless there is a wiring fault.
If the screw doesn’t match up, you’ll know you have placed the new panel incorrectly and will. I have tested the thermal fuse and door switch, and i believe the problem to be the main control board. Now, you must press the “more time” button followed by the “less time” button and then repeat that sequence once more.
Start By Plugging The Dryer In But Don’t Run Any Cycle.
Use a multimeter to check the fuse for continuity. Make sure that the control housing assembly is properly inserted in the front console. This is an expensive part, and once installed it cannot be returned is my understanding.
As Your Load Of Laundry Tumbles In The Drum, It Makes Contact With The Sensor Strips So That The Dryer Can End The Cycle When Your Laundry Is Dry.
How do you remove the control panel from a whirlpool duet dryer? That’s the only thing that would make it act like that unless there is a wiring fault. I followed the instructions in the tech sheet and decided the control board needed to be replaced.
Press The Start Button And Hold For Several Seconds To Restart The Dryer If Pf Appears On The Display.
Whirlpool electric dryer gew9200lw1 my repair & advice. Place the probe on the timer’s terminal a with the red wire. The door lock switch tells the.
If The Dryer Is Not Level, The Sensing Does Not Work Properly, And Your Drying Cycle Will End Early.
Tried new control board, and both boards for user interface. I think i meant to say the control board when i said panel. Next, kill power to the dryer for about five minutes.
Make Sure Your Dryer Is Still Unplugged!
Remove the two hex screws located on the rear of the top panel. To install the new control board, first make sure you have the correct board. The door lock solenoid locks the washer door.
Post a Comment for "How To Test Control Board On Whirlpool Duet Dryer"