Kenmore Refrigerator Control Board Flashing 6 Times
Kenmore Refrigerator Control Board Flashing 6 Times. You should refer to your manual for information. It manages cooling in the refrigerator by controlling the compressor.
If a refrigerator is not staying cool because the compressor. That tells you the light is reset. Kenmore 106 models are made by whirlpool, and whirlpool doesn't make a schematic for just the defrost board, as parts on that board are not sold separately by whirlpool, they make a schematic for the complete refrigerator, it should be located behind the bottom kickplate grille.
Led Blinks 6 Times, Then Repeats (Current Trip).
After resetting power, check if it is running normal. Hold them for about 3 seconds or until you see the filter light blink. Turned off alarm and turned off quick freeze.
If The Problem Seems More Complicated Than Something You Are Comfortable Fixing On Your Own, Contact The Manufacturer Or A Certified Repair Technician For Assistance.
Flashing 6 on the fridge display: As i tell you,i replace control board with a new board.but led was flashing 6 times.the i get new compressor. I check all temperature sensor it reads about (9k ohm) also i check fan it work good , the reading voltage 12.5v and feed back signal is about 2v.
I Noticed It Turned The Compressor Off For A Few Minutes While All The Fans Kept Running.
Allow fridge to get back to temp on its own: It manages cooling in the refrigerator by controlling the compressor. Check the flame rod position and make sure it's not oxidized, broken or disconnected.
It's A Variable Speed Compressor So There Is No Way You Can Actually Test To Make Sure That Is Accurate, But In Short You Either Have A Bad Compressor Or A Bad Control Board Not Reading The Compressor Properly.
Once in test mode 3, you can reset your lg refrigerator if needed. If a refrigerator is not staying cool because the compressor. 6 blinks means that the refrigerator is detecting the compressor drawing too much amperage.
If This Doesn’t Work, Follow Any Specific Instructions In The Correct Owner’s Manual Pertaining To Your Model.
Communication failure between main control board and user interface control : Led flashes 6 times and then 1 time every 3 seconds problem: Kenmore 106 models are made by whirlpool, and whirlpool doesn't make a schematic for just the defrost board, as parts on that board are not sold separately by whirlpool, they make a schematic for the complete refrigerator, it should be located behind the bottom kickplate grille.
Post a Comment for "Kenmore Refrigerator Control Board Flashing 6 Times"