How To Replace Control Panel On Ge Washer
How To Replace Control Panel On Ge Washer. The start button is made into the control board so in order to replace, you have to swap out the whole board. Reconnect the air hose down to the back of the control board.
This procedure shows how to replace the machine control board (also known as the main electronic control board or mother board) in kenmore, kenmore elite, lg, whirlpool, maytag, samsung, ge and. Unplug the washer from the wall outlet. If this video does not help, service may be needed.
Flip The Panel Over And Lay It On The Top Of The Washer;
The short was so bad it caused our smoke alarms to go off. For service, please schedule an appointment with ge appliances factory service. Now you can just remove the 2 screws coming from the back side of the control panel and pry up on the plastic clips along the top of the control panel from the inside of the dryer and the control panel will pull forward and off.
Using Your Photograph Or Other Documentation As A Guide, Connect All The Wires To The Back Of The New Control Board.
Reinstall the screw on the back right side of the control panel. Remove the screws holding the control panel in place. This will disengage the clip from the bolt head and allow removal.
Plug In The Wire Harness Connections For The Control Panel.
Push the detergent dispenser back into the. Insert the mounting screw in the control board housing and tighten it firmly. Pull top of front panel forward, lift up and off bottom locating tabs.
Now We're Ready To Push The Washer Back Into Position.
I had to replace the control board because the button on my washing machine was pushed so hard that it actually broke the button on the control board. One stiff blade putty knife. Use caution, as it is still connected to the machine by wires.
We May Need To Flex Either The Front Cabinet Or The Front Panel And Then Snap The Front Panel Against The Cabinet.
Ge washing machine control panel. The top panel will then pull straight back, up, and off. Listed below is the procedure for removing the front panel.
Post a Comment for "How To Replace Control Panel On Ge Washer"